Set the Count (the number of input buses you are adding), select the Configuration ( Mono, Stereo etc.), enter a Bus Name for the input buses and then click Add Bus. If the bus list beneath Bus Name is empty, click Add Bus to add at least one input bus. Under the Inputs tab, the input buses need to be set up if they are not set up already. To configure this in Cubase, go to Studio on the menu bar at the top of the window, and select Audio Connections. Monitor Controls (Optional) Part One: Cubase Audio Connections The Audio Connections Window Routing Playback and Inputs (Direct Monitoring)ģ. Routing Playback Only (Software Monitoring)Ģ. The number of monitor speakers and headphones you can use depends on how many inputs and outputs your audio interface has, some steps may not be possible with all audio interfaces.īefore following the steps below, ensure you have completed the initial setup for your audio interface in Cubase as detailed in the following article: Cubase: Setting up Focusrite interface. This diagram shows an overview of the setup: See the Focusrite Control Scarlett 3rd Gen User Guide for more information. This can be configured in Focusrite Control in Device Settings. Third-generation Scarlett 18i8 and 18i20 have a built-in Speaker Switching function. Separate cue mixes for two performers (a guitarist and a vocalist), one via a headphone amp connected to a pair of line outputs, and the other via one of the built-in headphone outputs.The same main mix is also on headphones for the engineer.Speaker switching so an engineer can monitor the main mix on two different sets of monitor speakers*.A dedicated talkback microphone that can be switched on and off to communicate with the performers in their headphones only. The example below shows the following functionality using the inputs and outputs on a Clarett+ 8Pre: To access the Control Room in Cubase, select Studio on the menu bar and then Control Room to open it in a separate Window, or it can be found in the Project and MixConsole windows in the Right Zone by selecting the CR tab. The Control Room provides talkback functionality for communicating with performers via a microphone, separate cue mixes for each performer's headphones and switching between sets of monitor speakers. This guide explains how to set up Cubase’s ' Control Room' feature for use with Focusrite interfaces.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |